Microcom 450 User Manual

MICROCOM CORPORATIONLABEL DESIGN SOFTWAREFOR MODELS1100, 1400, 20002150, M450, M460M650LDS100/140/200/250/450/460/650REV 2.2NOVEMBER 11, 1988©1988 Mic

*1 The default for these elements depends on the character generator used (CGN).*2 The default for this element depends on the text conversion

25 MSI 2 26 MSI 3 28 MSI Human readable type 1 29 MSI Human readable type 2 32 UPCA human read

CS CHARACTER SPACINGThis element determines the spacing between each character. Ifthis element is not used, then the default value for theselected c

Switch Bank One (Top set of switches)1 |Response to enquiry ------------> 1 22 | ------------------------3

‘SCG1DO’ FOR PRINTER WITH LDS SOFTWARE 88.06.18The following letters (NURL)

BARCODE GENERATORSCODE NURL CODE RATIO SPACING NO.1 C392 NU C39 2/1 1 3 NU C39 3/1 14

1. INTRODUCTIONThe Label Design Software (LDS) is a powerful and easy to use packagethat allows the user to create his own label formats. LDS supports

BS ^H Same as DEL but has another special function.LF ^J No effect.VT ^K Print a test label.FF ^L Print a blank label.DC3 ^S Instr

2.4 ^C PRINT MODEThe print mode instructs the print to start the print cycle.If the printer has not been instructed to print multiple copies thenonl

63 Load text mode control byte 0 Disable auto text mode entry and clear text control 1 Enable auto text mode entry (^B is optional)

96 Load keypad queuing number 0 Disable keypad queuing 1 Print first label then queue for remainder 2 3 Disab

These control codes are listed in order of priority. The SUBcharacter can only happen on the first poll after power up. Also theSUB character can be s

3.1 HEADER DESCRIPTIONA header is broken down into thirteen different elements. Theseelements contain information about the label. It is not necessar

label instead of the leading edge. If it is set to a value oftwo, then the printer will not wait on the gap detector. Instead,it prints